YYX144 YT272001-AG ABB Subject to any electromechanical contact

For the selection of these types of safety oriented devices applicable norms and standard shall always be checked.

The ASTAT accepts nearly any choice of electromechanical contacts (110 V DC).

Static inductive type limit switches can be used. Requirements:

• NO-type
• Two wire cable moulded into switch
• IP 67 protection preferred
• Range at least 40 – 150 V DC
• Continuous current: at least 15 mA
• Switching frequency: 8 Hz for DC.

For use as Overspeed monitor: only 100 Hz types are approved for use.

• Installation temperature: To check
• Approved types:

ifm electronic gmbh, Postfach 10 18 33, 45018 Essen (Teichstrasse 4, 45127 Essen), Germany,

phone +49 201 2 24 20, fax +49 201 2 42 22 00.

Tested versions: IG0005(Plastic tread M18x1 / 5 mm / flush mount / 100 Hz),

IG0006(Plastic tread M18x1 / 8 mm / non-flush mount / 100 Hz),

IG0011(Metal tread M18x1 / 5 mm / flush mount / 100 Hz),

IG0012(Metal tread M18x1 / 8 mm / non-flush mount /100 Hz),

II0005(Plastic tread M30x1,5 / 10 mm / flush mount / 30 Hz),

II0006(Plastic tread M30x1,5 / 15 mm / non-flush mount / 30 Hz),

II0011(Metal tread M30x1,5 / 10 mm / flush mount / 30 Hz),

II0012(Metal tread M30x1,5 / 15 mm / non-flush mount / 30 Hz),

ID0014(Rectangular Plastic / 50 mm / non-flush mount / 8 Hz),

Tested versions with shorter distances for rigidly supported mounting:

IN0073(Rectangular Plastic / 2 mm / flush mount / 50 Hz),

IN0081(Rectangular Plastic / 4 mm / non-flush mount / 50 Hz),

Explanation of measurements:
Rfr:
Ground fault resistances between 0 and 29.8 k can be determined and displayed. A display of 29.9 k or 30 k indicates a ground fault resistance >29.8 k. A value of 29.9 k
or 30 k is displayed when there is no ground fault.
A whole number between 100 and 111 is displayed for the
fault code in cases when it is not possible to compute the
ground fault resistance.
100.0 means no injection for more than 5 s.
101.0 means incorrect frequency. Either the injection frequency on the REX 010 or the rated frequency on the
RE. 216 is incorrectly set.
102.0 means external open-circuit.
109.0 means that both the binary inputs ‘AdjREsInp’ and
‘AdjCoupCInp’ are enabled.
111.0 means that the binary input ‘AdjRErInp’ is enabled.
No other codes will normally be generated, but if they are,
they are a diagnostic aid for the specialist

The prices of all products of Zhangzhou Fengyun may fluctuate at any time. The specific price is subject to the customer service quotation. Please confirm the model, product, price and other details with the customer service before placing the order. Second-hand and brand-new products are sold in the store. Please contact the customer service for details.

Recommended ABB related models：